Senior Electrical Engineer, Connected Warfare Ground Vehicles

ABOUT THE TEAM

Connected Warfare is the team at Anduril dedicated to the modernization of the command and control systems of U.S. and Allied forces. New technologies and new adversaries demand a new approach to battlefield intelligence, and you will be the driving force behind the integration of cutting-edge edge compute and communications technologies that make that approach a reality.

Energize your career as an Electrical Engineer at the forefront of military innovation! Our elite team seeks a dynamic individual with a passion for electrifying the battlefield through advanced power conversion, battery systems and smart controls via tightly integrated system architectures.

WHAT YOU’LL DO

• Design, develop, and deploy state-of-the-art power systems tailored for extreme performance and reliability in demanding environments
• Engineer the interface between high-capacity battery systems and sophisticated edge computing platforms, ensuring seamless operation and mission success
• Collaborate with a cross-functional team to push the boundaries of what's possible in power efficiency, contributing to strategic advances in military communications and vehicular technology
• Troubleshoot complex challenges, applying your expert knowledge to maintain the strategic advantage on land, air, and sea
• Work on building the future of military vehicles including smart power systems, edge compute, combat, network and RF communications
• Lead or support full cycle PCB design including defining requirements, schematic design, component selection, supervision or completion of layout, bring-up, test, debug and integration with the system
• Define, architect, test and integrate modules and subsystems into full vehicle system including hardware selection
• Develop communication architectures for CAN, ethernet, and serial based electrical devices
• Plan and document power and signal interconnections between system components through definition of block diagrams and harness schematic drawings that connect electrical equipment within the vehicle
• Build vehicle electrical bench setups and HIL systems to facilitate bring-up, development, testing and validation
• Troubleshoot issues that span the electrical and firmware/software boundaries using lab test equipment
• Work closely with other electrical, mechanical, harness, firmware, software, and test engineers to deliver fully functional products
• Conduct peer-level and cross-discipline design reviews
• Work in a fast-paced environment supporting new developments, deployments, and customer operated hardware

REQUIRED QUALIFICATIONS

• Bachelor’s Degree in Electrical Engineering or equivalent, with 7+ years of experience designing, testing, and troubleshooting complex system designs
• General understanding of engineering concepts, principles, and theory with technical experience demonstrating the application of those concepts while ensuring safety and regulatory compliance such as grounding and fault protection
• Hands-on technical experience with integrating and debugging complex power and communications systems as well as firmware-controlled electrical or electromechanical devices
• Experience designing mixed-signal PCBs with multiple layer counts, layer stackup and impedance matching for power and sensor applications, understanding correct grounding approaches and employing appropriate board protections and filtering
• Understanding of low voltage and high voltage power electronics and control systems in order to capture system interconnect diagrams and drive cable harnessing designs with proper wire and connector selection
• Ability to perform power system and electrical loading analysis, simulation, and testing to determine optimal solutions
• High competence using lab test equipment (bench-top power supplies, electronics loads, oscilloscopes, DMM, logic/spectrum analyzers, etc.) with familiarity of thermal and EMI test chambers and using basic software debugging tools
• Familiarity with battery and UPS systems of various chemistries along with high voltage and low voltage safety and design considerations
• Familiarity with common electrical bus interfaces (CAN, I2C, SPI, Ethernet, RS232/422, RS485, USB)
• Exceptional organization and communication skills (both written and oral)
• Eligible to obtain and maintain an active U.S. Secret security clearance

PREFERRED QUALIFICATIONS

• Understanding of MIL-STD requirements such as MIL-STD-1275, MIL-STD-461, MIL-STD-810, MIL-DTL-38999
• Familiarity with military ground equipment vendors and rugged system component suppliers from past experience in DoD programs